FLIP TOP COVER

INSTALLATION INSTRUCTIONS

1. Turn the case upside down. Your console should have 8 screws under the square plastic pieces.

2. Pop out the plastic screw covers with a butterknife or a screwdriver and unscrew all the screws. Remove the Sony warranty sticker. This is done just by pealing off the sticker.

3. Once done, turn the console the right way up, and left the case VERY CAREFULLY forward and up.

4. Carefully take off the lid slowly. There is an eject ribbon attached and you do NOT want to snag it.

5. Next remove the four small screws holding the CD assembly cover on. Once they are all off, simply lift up on the lid and remove it.

6. Next take out the white plastic spindle hub that sits inside the CD assembly cover you just removed. It should slide out.

7. Next place the plastic hub in the your new Magic Case. The metallic part should face to the top.

8. Now place the reset, eject parts into the Magic Case as if was the original Playstation 2 case. Sometimes it is better to use some small tape to make the eject tray ribbon tidy and sometimes use an extra screw to keep the reset/eject part in place more secure. There is an extra screw hole that was added just for this purpose if needed.

9. Now slide back on your new Magic Case lid and screw back in the screws. Replace the screw covers and you're ready to go!

BACK

HOME